Maintenance of the CNC Lathe Machine:
1.1 The new machine should be checked for 10 days to avoid loosening the screws during the running-in process. If loose, please tighten in time and check regularly.
1.2 Wood flour should be cleaned every 2 hours.
1.3 Oil should be injected once every 10-15 days of work. In particular, the sliding rails should pay special attention to refueling on time.
1.4 The tool holder bearing should be replenished once every 10-15 days of work.
1.5 The lubrication of the ball screw end bearing should be checked every 30 days of operation.
1.6 After working for three months, the new V-belt should be checked for wear. When the V-belt is too loose, the motor fixing plate should be used to adjust the tightness of the V-belt.
1.7 The lathe has a dust cover. The dust cover not only plays a role of dustproof, but also plays a role of ensuring safety. It should not be deleted casually.
Maintenance of Woodworking Lathes after Work:
2.1 Before leaving the work, the wood chips remaining in the body should be removed. In particular, sliding guides, rotating shafts and screw parts should be carefully cleaned without leaving debris.
2.2 After cleaning the sliding guide rail, the rotating shaft and the screw part, oil lubrication should be carried out in time. The lubricating oil should be high-quality bearing grease or machine oil. The use of steam, kerosene, diesel and other diluent oils in place of lubricating oils is prohibited. No oil shortage!
2.3 The fasteners should be checked regularly and closely, otherwise the fasteners may be loosened due to long-term vibration. This will lead to increased vibration, mechanical wear becomes faster, and the equipment will not work stably, resulting in reduced accuracy of machined parts. Ripple and deformation appear. If you find this situation, you should tighten it in time!
2.4 There should be no debris near the mechanical limit switch. There should be no hanging metal objects hanging over the sensor. Failure to do so will result in mechanical failure and the switch will fail.
Whether it is a human or a machine, you must bow your head obediently in front of time. At a certain age, people are attacked by undesirable symptoms such as wrinkles and rough skin, and machines are threatened by a decline in performance when they reach a certain age. This situation is inevitable, not to mention that if the staff does not operate properly, the time for the aging of the machine will be advanced. CNC lathe is a very popular mechanical equipment in the industrial field. Like ordinary machines, it will fail when used, but the time of failure of woodworking lathe manufacturers is more refined. Usually the time of lathe failure is divided into three stages.
The first stage is the early stage of use. The probability of failure of the lathe is high. Because it is just used, the lathe cannot enter the state quickly. At this time, if the operator treats it as a lathe that has been used for a long time, overload will occur in the process. In the second stage, after 9-14 months of use, the lathe is not prone to failure during this period, so it can be used normally; the third stage is the aging time, which is the peak period of frequent failures, and the machine needs to be focused Protect. Use double-knife CNC woodworking lathe: The so-called double-knife refers to the configuration of two turning knives on the woodworking lathe, one for roughing and the other for finishing, one in tandem and the other at the same time, which can make the log smoother.
